Shenyang Qiangsen Machinery Equipment Co., Ltd.

, Adjustment of the rear supporting device of the fully automatic edge banding machine
-- When the edge banding machine works in a wider area, it is necessary to adjust the rear supporting frame so that the small roller surface of the supporting frame is in contact with the conveyor chain The plates are on the same plane, and the method is as follows
:

- Close the two processing plates and place them at the head and tail of the transmission chain plate, and press them tightly.
b
-- Pull out the support frame to the appropriate position.
-- Loosen the bolts fixing the support frame, make the upper surface of the support frame contact the lower surface of the workpiece, and then fix the support frame.
-- Adjustment of the feeding and pressing beam device of the fully automatic edge banding machine
-- The height of the feeding and pressing beam device is mainly adjusted according to the thickness of the workpiece.
-- The adjustment method is as follows:
-- Determine the adjustment amount according to the thickness of the workpiece
-- The displayed thickness is the thickness of the workpiece.
-- , Adjustment of the dissolving glue coating device
-- , Adjustment of the glue coating amount according to the adjustment direction marked on the label panel, twist the adjustment handle by hand to adjust to the required glue amount.
-- Please press the temperature control button to adjust the dissolving glue temperature