Four preparations before operating the panel saw
. Clean the machine and the working area.
.Check whether the vacuum system is normal.
3. Check whether the saw blade of the sliding table is sharp and whether the large and small saw blades are in a straight line. Test the machine for about one minute to see if the machine operates normally
. Prepare materials and accessories
Correct operating steps for panel saws
Many customers do not know how to use a panel saw after buying it, and do not know how to operate it The program mainly follows the following steps, and you can use the panel saw normally
. Check the power switch before starting the machine to see if the air pressure reaches...~.
. After returning to zero, use the cutting edge to test the machine (cutting).
3. Read the order carefully, calculate the required number of plates according to the cutting instructions, enter it into the computer and wait for the next step.
.Place the plate on the pusher and adjust the gear size.
.Adjust the cutting speed according to the hardness and thickness of the plate, and push the pusher at a constant speed
.When the plate is cut out to the left and right, the picker starts to pick it up with his hands, keeping the plate moving until the end of cutting.
During the cutting process, large pieces should be cut first, and small pieces should be cut with offcuts to ensure the optimization rate of cutting.
.Every time a plate of one specification is opened, a first-piece self-inspection must be performed to see whether the length, width, and diagonal dimensions meet the quality requirements, and whether the adjacent sides are maintained. (Simple judgment method: compare one of the synchronized parts with the next part)
. The cut plates should be placed flat on the turnover vehicle as required, and the plates should be separated by backing plates. Products of the same model are placed according to the requirements, paying attention to the protection of the corners.
. During the transportation of plates, turn off the motor to save electricity and extend the service life of the motor.
. After the operation is completed, cut off the power, remove dust from the machine, and clean up the remaining materials.
Factory direct sales of Daqing panel saws, what is the price of precision sawing panel saws? Johnson Machinery factory direct sales